Sunnen Releases New TC Tool |
||||
|
Sunnen's new TC tool is custom engineered for honing small two-stroke cycle engine cylinders to overcome characteristic production challenges, including blind, ported and tapered bores and hard surface coatings, such as Nikasil and chrome plating. Proven in production by major OEMs in Sunnen and other manufacturers' machines, the TC tool is designed to produce fractional micron (0.000040-inch) accuracies and specific surface finishes for increased power production, fuel efficiency, reduced emissions and engine durability. Equipped with metal-bond superabrasives, TC tools use customized abrasive mounting that holds up to a dozen stone segments of various lengths. Strategic placement of the abrasives is intended to produce superior roundness and a consistent finish from top to bottom in blind bores. Each tool is tuned to the application based on length and number of abrasives to allow the tool to bridge across ports, minimizing washout of the port edges to maintain ring seal for increased power and engine life, the company said. Sunnen
custom designs each TC tool by mapping the bore, creating a two-dimensional
profile to determine optimum length and spacing of abrasives to balance tool
wear and produce consistent bore geometry and dimensional accuracy over
thousands of parts. |
|
|||
|
TC tools begin with hardened tool steel bodies and feed wedges and typically last up to five times longer than conventional designs, reducing per-part cost by 30 percent, the company said. Custom-engineered TC tools are capable of producing accuracies of 0.6 µm (0.000027-inch) for diameter, roundness, straightness and taper. They are available for bore sizes 25 mm (1-inch) and up. Honing with the TC tool is a suitable process for small-engine OEMs striving to meet the 2011 EPA standards for two-cycle engines, producing precise bore geometry and surface finish with the consistency needed for mass production. TC tools are also part of Sunnen's high-production honing system for two-cycle engine cylinders that includes the SV-1000 series machines, with options for closed-loop gauge feedback control and robotic loading/unloading from a pallet. For more information contact: Sunnen Products Company 7910 Manchester Avenue St. Louis, MO 63143 800-325-3670 314-781-2100 Fax: 314-781-2268
|
||||
